[عمادالدين جمعة]

cx 2414

--------------------------------------------------------------------------------Set TAP chain and create a CPU module
Use the ARM9 CPU module
CPU module has been successfully created
The configuration of the Tibet Autonomous Region - 2 8 / 0 0 / 4
Reset the TAP
Read the ID of the processor
CpuID = 0x20920027
Read the IMP code
IMP code is not supported
ARM part number = 0x0920
Core with MMU
Family ARM9
Initialize module ARM9 ....
DBGCTRL = 0xD
The processor is stopped in ARM.
ID reg val = 0x41129200
CPU module initialized
Use the ****** file 24170.ejs
****** Executed
Create a module of flash
Check depending on the processor
Module> AMD16 ARM9 DCC <requires the type (s) processors:
MIPS PrAcc
ARM7
ARM9

Depending satisfied
**** address = 0xF0000000
Access mode 16-bit / 16 bit
Fast reading of 8192 bytes
Quick entry to 2048 bytes
The first 16 bytes of Flash at offset 0x0:
40F0 9FE5 0000 0000 0000 0000 0000 0008
Determine the flash ...
Manufacture ID = 0x00C2 Device ID = 0x22A8 22A8 22A8
CFI = Q, R, Y
Boot type = 2
CFI flush found
VENDOR ID = 0x2
AMD compatible
Flash Size = 4194304
Region count = 2
Region = 0; Block size = 8192; Block count = 8
Region = 1; Block size = 65536; Block count = 63
Use the fast mode, block = 8192 bytes
Reading 4194304 bytes at offset 0x0
Write to the file C: \ _Project_ \ _Lazar_prj \ CPLD_EJTAG \ test.***
Reading started
0:34:39
Reading completed
0:35:29
Average speed of 82.6 KB / sec